Posted by Lefty on February 02, 2011 at 16:57:24 from (174.124.37.89):
In Reply to: Re: Filling silos posted by Ky Hauler on February 02, 2011 at 11:40:16:
Bout 70,had a crew there building us a new 18'x60' concrete stave silo.Weekend was comin and crew decided to work late and get the roof on before quitting.As we started milking,a noise not unlike a bad car crash came from the feedroom and we ran,to find total destruction inside the new silo...the centerpole scaffold bearing 3 man crew and all the sheet metal roof sections,scaffolding planks,tools etc had collapsed.After what seemed an eternity the 3 men crawled outta the wreckage with non life threatening injuries which Mom(an RN) dealt with quickly and 1 fella needed a few stitches at the hospital.18yoa"greenie"on the crew had driven 80 mi to the job that day,was sufferin so badly from mental shock that Ma tool his keys and sequestered him to the spare bedroom overnight. Apparently a stop pin shook out of the scaffold pole,and when the went to add last section,the lift cable snapped at the hook,giving them a helluva 60 ft ride. :(
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.