Posted by soder33 on January 31, 2011 at 10:31:44 from (156.98.4.11):
I inherited 62 acres of land of which 25 to 30 acres have been in crops (corn and soybeans). There is not a lot of demand for farmland in the area,(land is near a city and the best use would be development) so it was only getting $1700 in rent for the year. This is about a 1/3 of the property tax. The land is on the market, but in the year it's been listed, no offers have been made on it. Must be the recession. So, I was thinking of putting in my own crop, but don't have a clue as to what that should be. I would like to make enough to pay the taxes and cost of putting in the crop without my labor. I would also take it off the market. Keep in mind that my largest tractor is a 1950 John Deere B and I also have a 1952 Ford 8N. I would need to buy or rent most of the impliments for tillage and also harvesting. My thoughts were to put it into hay, as there are alot of people in the area with horses. Anyone have any thoughts? Your wisdom is much appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
