Posted by Nofbdybs on January 27, 2011 at 05:16:51 from (70.153.188.190):
In Reply to: How to disc a field? posted by Nofbdybs on January 25, 2011 at 18:11:38:
FWIW, I am in louisiana. I will not be building on the land, my house is connected to it.
Im using our Yanmar 336d, the disc is a small, 5ft unit, but a heavy one, it was able to cut very good last year. Box blade is a standard 5ft unit.
I had a few issues with pocket Gophers last year, but I was able to trap them out real easy. It did have a ton of old roots, I was able to get a few truck loads out. Also, there was some old concrete there, and an old gas line. Before I got the land, timber was there. It was cleared out, and all the stumps removed, but the skidders and dozers made the land VERY rough. I was able to get it more than smooth enough for a ZTR to hit. There are just a few spots that are still not to my favor. Also, the land dips down towards the rear, and over the years, some of the topsoil has washed off. I need to replace that. I would have done it all last year, but my wife, and little girl were put in the hospital at about this time, and I didnt get to finish it.
Also, the term "Golf course smooth" is apparently a touchy term.
What I ment, was relatively smooth. Our little girls ride thier bikes there, play ball, ect. Also, my wife jogs around it.
So, smooth enough for that.
This post was edited by Nofbdybs at 05:19:03 01/27/11.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.