JDseller, I'll have one more more look at the cylinder head for a fitting. Funny place to apply heat, though, because heat at the top of an engine won't circulate downward. I'd rather see heat enter the lower side of the block. Diydave, there IS a drain fitting, halfway to the rad, in the lower hose, and a thermostat bypass hose, so I probably COULD make a tank heater work. But they are bulky things and there is just absolutely NO room under the hood. I'm not saying it can't be done, but it might need to hang over the front axle or something. If I run out of options I might have to try it. Ivan in Mich, Kubota placed each frost plug hole over each cylinder, where the coolant passage is shallowest, instead of between the cylinders. I'm told there just isn't enough depth for ANY frost plug to fit. Too bad, because frost plug heaters dissipate less heat into the surrounding air than any other type of coolant heater. They're also pretty cheap and take up no space. I gotta say, I am REALLY tempted to remove a plug anyways, just to see if I really can't find a frost plug heater to fit. Philips and Temro have both a 400W and 600W heater that might fit. Maybe my neighbours are wrong.
My tractor sits out in the cold wind. I am running a synthetic Shell 0W30 oil in most of my equipment, including my truck. Nothing else flows at these temperatures. I must say, though, that everyone here has told me the same thing: build a garage, even an unheated one. Even though I may get the engine started, the transmission and hydraulics don't like these extreme temperatures. And I can't put heaters on everything. One friend burst his hydraulic pump some years ago in; it just split open trying to push frigid oil and the internal relief valve somehow didn't do its job. Hard to believe. Paul
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
