Posted by Goose on January 23, 2011 at 17:43:54 from (67.63.68.13):
This is a farm house I rent out. It was built in 1928, and is still in excellent condition and in perfect plumb, well insulated, fairly new high efficiency furnace, central air, etc. Except the corner of the enclosed porch facing the camera has settled. If you shoot a laser the long way, the corner has dropped about an inch and a half.
I also need to redo the two walls that are facing the camera. It was a screened porch originally, and was later closed in. The two outside walls facing the camera are shot. The long one is 22’ and the short one is 8’. There is dry rot in the window sills and from settling the window and door frames are cockeyed. The windows are single pane and not too efficient. Redoing this will add to the value and rentability of the house.
What I’m planning on doing is replacing the walls, have fewer windows, eliminate one door, (haven’t decided which one, yet), and jack the corner back to level in the process. I’ll obviously use energy efficient windows and doors, and insulate it well. Also put vinyl siding on it to replace the original wood. I intend to eventually put vinyl on the entire house. Maybe not this year, but soon. Getting this porch back under control is the most urgent. My present renter is leaving in a month or two, and if the weather cooperated this would be a good time to do it before I get new tenants.
My question is, when is the best time and the best way to level the floor? Obviously, the windows and doors need to be removed first. Would you jack it level before removing the old walls? Prop the roof from the ground, remove the old walls, jack the floor level, then lift the roof to match a standard wall, and lower the roof to sit on the new walls? Put props between the floor and the roof, remove the old walls, and level it before installing the new walls?
I’m aware that weight is a consideration, and if it’s feasible I like the idea of propping the roof to the floor, removing the old walls, and leveling it before the new walls are installed. Obviously, I also don’t want the roof to get away from me and come down.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
