Posted by 60 acre hillside on January 20, 2011 at 17:02:31 from (67.142.170.20):
In Reply to: Re: Two bladed saws posted by Mike (WA) on January 20, 2011 at 12:41:58:
Buy the VERY BEST Wiss inlaid 14 i/2 inch straight snips and never look again for any power tool. May cost a lot and cannot be bought at a lumberyard or chain store. You need to go to a contractor's supply house. Small or cheap ones will not do it very easy. Ask a union sheetmetal worker. As an apprentice we cut 20 and 22 ga all day long up to 10 ft cuts. Put thumb through top handle and fingers through bottom handle and slide bottom handle on the top of work bench. Use palm of hand to press down on top handle. Lean snips with the top blade away from the sheet. When I was an apprentice the journeymen would pass their well oiled but worn snips down to his apprentice. We oiled them every night.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.