Well George, What I have done since then is put in removable hitches. On the goose neck, after you unhook and pull out from under the hitch, you just remove 2 pins ad drop the ball receiver off and take it with you. I then have a plug that I push back up into the neck and put the pins back through and lock. The pins are made of tool steel so there isn't much that will cut them. On the bumper pulls I chain a steel chock up between the tires on one side so it jambs against both tires. I guess that you could take a tire off once you break the locks and chain an axle up but that I think would draw attention. The other thing I do with the bumper pulls is I get a cheep ball of the right size and cut the stem off it so its just a ball. Then I push it up into the hitch and lock the hitch with the ball in it. That way they can't get under it with a smaller ball and drag it off. I also do this on all my trailers, and that is to lock the landing gear down so they cant get it up so they would end up dragging it down the road. The way I did that was to jack up the trailer to the level where it clears the ball and then add about 6 more inches. I drilled a hole through the leg area and inserted a tool steel pin with a hole in it and put a Trimax lock through it. I use Trimax locks on everything. But I have determined that a lock no matter how strong is only to keep honest people honest. The crook is going to get you if he tries had enough. LarryT
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
