Posted by willie in mn on January 08, 2011 at 03:01:16 from (205.188.116.74):
In Reply to: OT:Firewood post posted by JayinNY on January 07, 2011 at 19:23:44:
Guess I'm the odd one in this group, just adding so you all can laugh at my thinking. Grew up on the farm, only ones in the neighborhood that burned wood. Small chain saws hadn't been invented yet. Dad spent his weekdays during winter dropping trees with his hand saw & axe, cutting into about 8 ft logs. Dad, brother & I would spend every Saturday lifting these logs onto the buzz saw, cut to stove lengths,& hauling to wood pile. Had 2 woodpiles, one to build for curing, other that had cured for a year to burn from. Every day after school split with axe or sledge&wedges, lug to the house & throw through cellar window. Left the farm right after graduation at age 18. Swore that as soon as could write check for nat gas, never burn wood again. Fast forward to retirement. Moved into a lake home. Original log cabin that has been upgraded with 4 additions, part on crawlspace, part on slab. Had a wood stove in it with nat gas for backup. Only on 1/2 acre, so had to buy wood. Haul it home, stack porch full, pile the rest outside. Carry thru kitchen to stove. Used that 1 winter, next year swapped to pellets. Burn about 4 ton a year, gas kicks in to help if temp gets down to around zero outside. Pellet stove puts out enuff heat, but due to shape of house, circulation is a problem, even with ceiling fans. Only wood i burn now is in fire ring to roast hot dogs & marshmallows in summer when grand kids are here. Not knocking those who heat with wood, but this is my choice, I'm sticking to it. Willie
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
