A friend of mine told me that I should take a civil service test because the County would be hiring lots of people for Expo 74. I took the test and ended up doing very well and got hired. I stayed with that department for 25 years, and would probably still be working if I hadn't come up with health problems.
I had trained to be a science teacher, but never really used that training at all. And my bachelor's degree never earned me any incentive pay, like a degree would have in some other jobs. I did have a VERY GOOD TIME in college, though!
I have always wondered if I would have liked teaching better than what I did. But my job payed better than teaching, and was usually fairly interesting. I had been a fireman while in college, and decided that while fire fighting was very interesting when you had a fire, most of the time there was little or nothing to do. Really boring!
I have not regretted working in the public sector, although I might have made more money in private industry. Although the pension system that new hires today is not nearly as good as the one I am in, it is much better than most in private industry. Unless the state goes bankrupt, retirees in my pension system should be OK for the rest of our lives. Retirement is definitely something to consider and plan for.
It is pretty tough to give advice to someone on what they should do for a career, since something that is great for one person might not work at all for someone else. It is wonderful to have a job that interests you and is something you enjoy going to. I would suggest looking around to try to find something that is attainable, interesting and that will not be outmoded in 10 years. But specifics?--I sure don't know. Good luck!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
