Okay most of what has been posted I understand is is useful. I am going to determine if I can which sending unit I have and will then see if the gauge is a match.
So if I understand the gauge/sender premise.... WITHOUT the sending unit in the equation, if I hook up the keyed ignition wire to I and a ground wire to G on the gauge only, the gauge should remain on empty (no sender in the cicuit...no resistance) ... and if I have a working sending unit that MATCHES the new gauge, the resistance of that sending unit will provide contolled grounding of the gauge moving the needle towards full (grounded).
Do I have that concept or are you shaking your head and hoping I keep a fire extinquisher in the shop? I thought it would be handy to at least check the mechanical to electronic aspect of the sending unit by using a small meter. Will the simple ohms test sending unit wire to ground reflect varying ohms depending on float level? Mine seems to go right to pegged continuity with some gas......If not, how would I check the sending unit? How do you measure the resistance? Perhaps my little multi tester is not up to it? Also wondering if that is the only way to determine the type I have as no numbers are evident.
Appreciate the help. It seems like a little thing but it is such a pain to move the machine into a spot get it working on a stump or hole and then run out of gas because I forgot to climb up and peer in. I WANT a gas gauge!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
