.010" undersize requires a journal that is .010" smaller diameter, regardless is only .005" per side. Making any journal smaller makes it less strong.
I never said using undersize journals breaks cranks. I said it makes them weaker. Take a high-hour engine that will already have some metal fatique, and then grind it undersize - and it has to make it weaker - unless you have some magic process that makes less metal, MORE strong. We had a few .030" under cranks break. Now - as to why? I assume there were long-hour fatique cracks, and grinding .030" under was the "straw that broke the camel's back." Also, Deere claims that any crank-dampener with over 10,000 hours should be renewed it it also leads to broken cranks.
My point was, an still is - to blindly grind a crank that might not need it - is foolish. On the other hand, if a crank has bad journals - then there's aren't many options. Spray-weld the journals, grind undersize, or buy a new crank.
Deere sold .001" and .002" undersize bearings to install in standard cranks with slght wear. We did many and it's a very fix for machines that are only slightly out of tolerance and have low hot oil pressure at engine idle.
Just because a company sells a product to fix engines, does not mean, or prove - they certify it a fix "as good as new." Often the purpose is to get more use, that's all. Deere also allows undercutting armatures on diesel starter-motors - but also says they will not have the endurance of a new armature with a full-size commutator.
There are some old Deere #s for .002" bearings. Knowing the way Deere has dropped much of its parts support, they probably have to be source aftermarket now.
AT21108 0.05MM (.002" under) US, PLAIN (PKG. OF 2 HALVES) (2 USED GASOLINE) (4 USED DIESEL) Mains
AT21122 BEARING 4 0.05MM (.002" under) US (PKG. OF 2 HALVES) Rods
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
