Ran into the same thing a few years back when I got stuck on the backside of a construction site, late on a Friday afternoon, after everyone else left for the weekend. In my case it took me nearly 2 hours to go about 400 yards. The only machine to pull with was a D5. It almost didn't want to pull the weight in the mud, especially since the first half was uphill. That part of the pull wasn't so bad. There really wasn't much use in steering since the truck was sliding anywhere it wanted to anyway. And I can say without a doubt a 30,000+ lb truck slides anywhere it wants to when skating on a layer or red mud....
The second half of the pull was the challenge since it was downhill and side hill all rolled into one. So I set the brakes on the truck so it wouldn't roll into me, hoped it didn't slide into me, and began pulling. I went downhill to the left toward the exit, the truck slid downhill to the right. After digging out a pile of dirt that the truck slid into on it's adventure in the wrong direction I finally got to the gravel exit nearly hours after the first rain drop hit the ground. Like you said, I felt like I was about two feet taller from all the red mud sticking to my feet, and I think the truc left red marks on the road most of the way home...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.