Posted by Wardner on December 31, 2010 at 22:14:55 from (4.154.255.36):
In Reply to: OT- ARMY posted by JR. FRYE on December 31, 2010 at 12:19:26:
This is kinda OT to your topic but my recruit platoon at Parris Island in '65 had an Army E-5 transfer. He could only come in as a E-1.
I seem to recall that USMC re-uppers would lose one or two pay grades if they signed up between 1 and 30 days after discharge. After that, they would have to accept E-1.
No idea what goes on now-a-days but I am sure it is searchable at Google. Things change. My MOS (0141) disappeared about 40 years ago when the small echelons got computers. Shortly after that, the replacement MOS's were yanked out of the Rifle Companies and went to the Battalion H&S Company. Authorized company manpower dropped from 206 to 175. Other MOS's must have been moved too. At least they still wear, more or less, the same uniforms.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.