Posted by kseaton65 on December 29, 2010 at 08:47:21 from (99.235.224.152):
In Reply to: Need Help w/ oil pan posted by Poor farmer 830 on December 29, 2010 at 08:17:54:
if its a 4wd it will probably be faster to drop the front axle, if not it should come out after you remove the starter and torque convertor cover if its an automatic, gasket probably goes around the oil dipstick tube which may make it difficult to remove, if you can drive the tube up easily with a mallet do that if not, cut the gasket off, make a small notch in the new one on the inside to allow it to slip around, also i would personnaly get a tube of permatix Right Stuff Sealant and apply a small amount around the entire pan before you stick the gasket on, then put a bit in the corners were the pan dips for the rear main and front main bearings, can do it on the pan or engine side, the tube of RIGHT STUFF is more expensive but is worth it, works way better than regular RTV silicone
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Tractor Parade: Story of a Case SC - by Bernie DeLon. On a early fall morning back in 1994, I opened the newspaper and happened to spy an article about a local antique tractor club having their annual show that weekend.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.