Posted by Ralph WD45 on December 12, 2010 at 23:54:13 from (66.243.212.34):
In Reply to: Re: Just Stuff posted by jbp on December 12, 2010 at 08:17:04:
I guess it's each to his own! I am sure each of us has reasons that he owns, and drives what he does, For many years I traded every 2 to 3 yrs for a new Ford, but I had a good job with Boeing, and most people I worked with, was doing the same thing. Then prices started getting rediculos, and I bought this 10 acre place, and wanted to pay it down before I retired, so it would be manageable, when I did retire. I found an 80 dodge short bed that had an exceptional body, but a worn out 318, and bought it cheap. I went to the wrecking yard and bought a low mileage 89 318, which was the newest I could find at the time. I put the motor in, and took the truck to a paint shop, and had it sprayed, with new paint and clear coat. I then took it to Les Schwab tire shop, and had them replace any worn steering parts, and balljoints, and bearings,and give it an alignment. After 4 new tires, I had a total of $2300.00 wrapped up in it. Try buying a new truck for that in 2000! I have put a set of brakes on it, one U joint, and countless lube jobs, and oil changes,since 2000, and It has done all my comuting, along with feed hauling,seed trips down to Oregon, and used it to go to Popular Bluffs Mo. this past summer to see my son. When, and if it starts using oil, or loosing power, then I have the original motor setting on a pallet in the shop, covered up after being overhauled several yr's ago. By the time I need it I will probably have to have one of my grandsons install it!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
