BC, it does work as you suggest, you should sedate the animal near the place you will euthanize it, wait until it takes effect. Yes, you absolutely must have a halter on and someone holding the horse, but not in front of the muzzle, this is the hard thing because the person with the firearm has to stand directly in front of the horse to hit the mark you have made on the horses head, with someone controlling the horse with a lead shank from the side, with the shank over its nose. I forget the dimensions, good idea to be precise, but common sense applies, make sure the person holding the shank is out of trajectory, and to get some height we take em over to a small slope, when the horse is still, and the person holding is not in harms way, time to shoot, properly done he will drop, let out a big puff of gas out the back and probably drop some manure, his vitals may linger a bit longer. It is a good point because something tall like a draft horse, it would be difficult to stay perpendicular on the correct mark. I do not believe the skull is hard to penetrate, using a sufficient caliber, we have done it with a .22, .38 is much more preferable I think. I do not like any kind of point blank discharge of a firearm, I still say there can be risk, because a ricochet is very dangerous thing, though I believe the skull is not thick enough to withstand it, you really don't actually know do you, just like us, we're all different.
Always keep your distance, shooter has to be concerned if the horse stands up, you don't want to get struck, but like I said, done correctly, it is over instantly and is humane as it gets, just like you said, you have to be sure and hit that mark, or just have the vet do it, there is no in-between in my book.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Field Modifications (Sins of the Farmer) - by Staff. Picture a new Chevrolet driving down the street without it's grill, right fender and trunk lid. Imagine a crude hole made in the hood to accommodate a new taller air cleaner, the fender wells cut away to make way for larger tires, and half of a sliding glass door used to replace the windshield. Top that off with an old set of '36 Ford headlight shells bolted to the hood. Pretty unlikely for a car... but for a tractor, this is pretty normal. It seems that more often than not they a
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
