Thanks for the observations. Here's a little more info on what I have to deal with -
What I have is a 1000 foot long driveway as well as many buildings to clean up around. My FIL would use the 4430 with front mount Degelman blade and he'd do an awful job of it. That setup works well just blading the long drive, but it doesn't do so hot in cleaning up around the buildings. Last year, I'd start the 4430 to do the big blading, then start the 317 to do the outbuilding work, but I want to quit starting two diesel engines in the cold. I have an enclosed cab on the 317 and the 4430 is open station, and the 317 does a better job in the more important areas. Plus the 4430 is getting tired and starts hard, so the 317 wins the job.
I've been using the 317 with an 80 inch bucket, but once you get the bucket full, it's just like a V-plow and it takes 6 or more passes to do the long drive. So I was thinking that I'd use the 9 foot back blade on a 3 point to skid steer adaptor on the long drive then switch to the 80 inch bucket around the outbuildings. To get the blade to float, I plan on using a flexible connection to the third link - maybe a heavy chain. I also thought about putting skid shoes on it like 135 fan mentioned.
A new purpose built blade for a skid steer is ridiculously priced. I've also seen guys adapt pickup truck mounted blades to skid steers around here, but I don't think a pickup truck blade is built heavy enough to withstand the shock a skid steer can put on it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
