I had my truck aligned with a computer alignment place a couple of times and I think that as long as the guy doing it knows what he is doing,and does a good job,you can do great,much better than with a tape measure.If he is sloppy and doesnt have a lot of experience and know what to look for,you could be disappointed. Actually most stuff that I had done on my truck at a shop was not very good workmanship.Being a mechanic for 10 or 12 years myself,I know what good workmanship is,and usually stood and watched what they did unless I was dead tired.I have a cousin who works at a truck shop,and the stuff he did was good,the best I got in most cases.But that is kind of a rare thing.Some guys are real good at what they do,but he may work on your truck once and the next time they have the floor sweeper working on it and he makes it worse.Its kind of a tossup.Id like to see his work and hear what the customers say about him.But actually with a good mechanic doing the job,and knows the equipment,he should be able to get it right on the money with a laser.Should and what actually happens in real life might be far from reality.If you can trust them,they can do a good job.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.