Posted by Nebraska Cowman on December 05, 2010 at 10:03:32 from (66.252.115.12):
In Reply to: infrared heaters?? posted by dave2 on December 05, 2010 at 08:36:44:
A pasture tank? How big? How much ice/ How is it supplied? out here in cold country all we ever use is an axe and a pitchfork. We plumb the water in the bottom with a float valve and it never freezes. Yes, i have had to thaw a tank once that was froze solid clear to the bottom. Unknown to me some dummy had filled it at corn harvest time and when we turned in cattle after Christmas it was froze solid. What we did was start chopping with the axe til we got a nice size hole and then turned in the water once we had a place for it. That one fed from a hydrant from the top. Had it been a bottom feed we'd be chopping yet. If you can get fresh water (50 degrees out of the ground) you can displace ice pretty fast. I wouldn't even mess with propane. the ambient air will rob all your nice heat.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Hydraulics - The Basics - by Curtis Von Fange. Hydraulics was one of the greatest inventions for helping man compound the work he can do. It’s amazing how a little floor jack can lift tons and tons of weight with just the flick of a handle. What’s even more amazing is that all the principals of hydraulic theory can be wrapped up in such a small package. This same package applies to any hydraulic system from the largest bulldozer to the oldest and smallest tractor. This short series will take a look at the basic layout of a simple hydraul
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.