Posted by doug in illinois on December 01, 2010 at 21:36:25 from (173.233.168.193):
I went ahead and bought a 91 Dodge 1/2ton 4x4, with Meyer 8 ft plow. 318 engine, short wheelbase so maybe not real nose heavy.
Last one I had was a 72 Ford Bronco 25 years ago. It had a 302. Even with it having the weight of the rear seats and fully enclosed it was light on the rear end plowing snow.
The last 30 feet or so of my driveway is kind of steep going uphill, I never plow snow across or into the county road anyhow, BUT wonder if I need some added weight in the box to offset the 8 ft plow.
I also wonder if I should chain up the rears, the driveway is blacktop and the yard by the house/garage is crushed rock.
At my "old" place, which I will still plow, either tractor would spin out without chains pulling or pushing on the slope.
As I said, all the snow will be pushed past the house into the yard, but have to make a curve and hill to do it. I am thinking rear chains at home, and just get a running start off the county road at the other place. DOUG
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.