Posted by NY Welder on November 30, 2010 at 07:27:53 from (67.189.228.218):
I have a Case 646 with a 16 hp Onan. The stator windings shorted to ground so I replaced them. The engine ran fine as long as the charging circuit was disconnected. The cowlings and flywheel had to be removed to access the stator. Everything went well with the repair and the system charges as it's supposed to, but now the engine will not idle properly.
The motor starts fine, but idles almost to the point of dying, then the govenor revs it, and the cycle continues. We removed the air cleaner to access things, but changed nothing else on the carb. The plug wires were removed to take off the cowlings, but none of the tune-up settings were altered.
The linkages for the govenor were attached to the front engine cowl and those had to be disconnected, so I'm thinking the problem may be there. Anyone out there have any suggestions as to how to fix this?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.