Posted by jcrane on November 27, 2010 at 17:29:08 from (69.84.72.149):
I posted this as well in the case forum, but thought I would post here as well.
I am looking at a diesel 730 case with a 830 engine. loader and grapple included. there is about 500 hrs on an engine overhaul, new clutch, straight tin and new paint. $4500 I was looking for a tractor around 90 hp. I am going to be round baling, handling a few round bales, hooking up to a 7ft snowblower, mild dirt work, etc...
I was just looking for a good all around tractor.
I am interested in the 730, but concerned that it might be too small. I am selling a MF65 because it is too small and was looking to upgrade.
My question is: Given the situation i described, would the 730 with an 830 engine fit my bill. ...and would it be a noticable upgrade from my mf65? My massey is also a gas guzzler and I am wanting a cheaper running tractor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
