Posted by 1941FarmallAboy on November 27, 2010 at 16:02:52 from (216.134.245.102):
hey guys!
Tractor is a 1949 Wd with a wd45 engine, It has a distributor, -Ground,
The old kill switch went bad so im going to use two toggle switches 1 for the kill switch and the other one for the lights.
The wire from the Voltage Regulator running up to the dash is the hot wire.
I need to know how to wire the dash up! I can get the lights to turn on and the tractor to start but how do I wire up the amp gauge and let the gen charge the bat? If it was up to me I would switch it to 12 volts but its not my tractor and its a working tractor so 12 would make more sence but its not my call. LOL
If my ? is not clear let me know, Trying my best to ask what i need to know.
Thanks!
This post was edited by 1941FarmallAboy at 16:04:28 11/27/10.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.