Posted by Don-Wi on November 15, 2010 at 19:04:26 from (75.219.120.192):
In Reply to: OT. Ideling a diesel posted by JayinNY on November 15, 2010 at 18:28:37:
For the turbo, the reason I was always told was to let the turbo and engine temp come down some before loosing the oil pressure and to also let the turbo slow down if you just got done running on the highway. Never heard of oil galling as a reason to idle, but they do say to idle for atleast 3 minutes.
For the warm up, as long as the engine is running on all cylinders and has pressure, you can go to work with it. Maybe start out light until it's up to temp, but it's not neccesary to idle that long. I'm guessing if you don;t do much to work it your deisel is starting to wet stack by the end of the winter season. Had a loader tractor (Oliver 1755) that was a diesel and that one would be wet stacked horrible by the end of winter. Just moving manure wasn't enough work for it in the winter so it never burnt all of the fuel. First chance we had we would work it some in the field to clear it up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
