Posted by Kentb of SWMO on November 15, 2010 at 06:41:29 from (71.30.131.57):
In Reply to: Magneto no spark posted by dan w MN on November 14, 2010 at 18:59:32:
On a Magneto,the kill wire terminal is also the insulated terminal of the points. This is also the point where the coils primary wire is connected. The difference in the resistance reading between the point being closed and open, where you read the resistance on the mag coils primary is most of the time around ONE OHM of less. Most ohm meters, especially digital's, can not tell the difference of one ohm and zero ohms. I have a few ohm meters. I recently bought a relatively cheap analog meter from MCM Electronic just for the shop. If it got damaged it would be no great loss. TO MY surprise, I found with it set in the RX1 range I could read the difference between open and closed points in a Magneto. It was a VERY pleasant surprise.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.