Posted by ChrisinMO on November 08, 2010 at 08:57:29 from (69.29.84.144):
My first job was working in an Orange Juice factory,but I got canned. Couldn't concentrate. Then I worked in the woods as a Lumberjack, but just couldn't hack it, so they gave me the axe. After that, I tried being a Tailor, but wasn't suited for it -- mainly because it was a sew-sew job. Next, I tried working in a Muffler Factory, but that was too exhausting. Then, tried being a Chef - figured it would add a little spice to my life, but just didn't have the thyme. Next, I attempted being a Deli Worker, but any way I sliced it... couldn't cut the mustard. My best job was as a Musician, but eventually found I wasn't noteworthy. I studied a long time to become a Doctor, but didn't have any patience. Next, was a job in a Shoe Factory. Tried hard but just didn't fit in. I became a Professional Fisherman, but discovered I couldn't live on my net income. Managed to get a good job working for a Pool Maintenance Company, but the work was just too draining. So then I got a job in a Workout Center, but they said I wasn't fit for the job. After many years of trying to find steady work, I finally got a job as a Historian - until I realized there was no future in it. My last job was working in Starbucks, but had to quit because it was the same old grind. SO, I TRIED Retirement AND FOUND I'M PERFECT FOR THE JOB!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
