You have to remove the lock cylinder FIRST so the bezel nut can come off.
To do this, turn it (IIRC) to the "ACCY" position and insert a straightened-out paper clip in the little hole near the key to depress a spring-loaded pin behind it that limits the rotation of the lock cylinder. While holding the paper clip in place turn the cylinder MORE to the left and it should then pop out.
ANY auto parts store with access to Standard Ignition, Neihoff, Echlin/NAPA etc., can get you a new switch.
HOWEVER, BEFORE going to all that trouble, disconnect the connector from the back of the switch and leave it hang. Then, with the battery disconnected, clip a jumper wire to the "S" terminal on the starter-mounted solenoid and bring the other end up top near the battery.
Make SURE the transmission is in "neutral" or "Park", connect the battery, then touch the jumper wire to a voltage source and note if the starter behaves normally WITHOUT the ignition switch in the circuit.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.