Posted by Inno on October 29, 2010 at 06:20:11 from (70.54.184.7):
In Reply to: Land Clearing posted by Steve in IL on October 27, 2010 at 20:28:53:
Depending on the size of the brush you might consider what we did. Had a guy with a 6' brush hog type mower on the front of a skid steer. He could cut up to about a 4" diameter tree, smaller if it was hardwood. The nice thing about his setup was that he could raise it up 10-12' in the air and start chopping up high then just bring it down and chew up the tree as he went. In one 8 hour day he was able to cover a lot of ground! Once he was done with that, I simply went and felled the rest of the larger trees by hand. I did have the use of a neighbor's skidder so that helped out a lot.
Now that was fun!!
In this area the brush was so thick you couldn't even walk through it.
This post was edited by Inno at 06:22:55 10/29/10.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Now that was fun!!