Posted by dave2 on October 27, 2010 at 15:17:07 from (139.139.35.70):
Hey folks,
I've got a cellar under the barn that I may be able to spend a little time on this winter. The floor is 2/3 paved with bricks and flat/sloped a little to a drain but the 1/3 on the end where the drain is has been dug in and has a pretty low spot that collects ground water when the weather is wet.
Haven't been in there in a few months and today there was no water collected. It's still wet outside, maybe a shift in the ground water (??). Anyway, someone before us used to store coal in there and there is a bunch that I was going to throw away (it's egg shaped pieces) and then thought I'd just use it to fill in the low spot tamp it and spread a couple inches of gravel on the whole floor with a bucket and pump set in the place where water used to collect with a hose running to the drain. Then, maybe I can get some use out of the cellar. With coal being in the ground for millions of years, it should do OK to fill the hole in my basement shouldn't it?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
