Posted by Donald plisco on October 22, 2010 at 18:04:36 from (67.217.199.9):
I just bought a 1965 Ford 2000, gas 3 cyl. A read of the serial numbers on the shroud showed that it was a 1967. Mechanically, it is in very good condition. I tuned it and a new oil change and it ran like a champion. The only trouble is that one of the rear tires shredded soon after using it to brushog a hillside. The rear tire size on both rears was 13.6x28 (standard is 11.2x28). Every thing I've looked up, doesn't show this size tire/wheel combination as an option on Ford 2000 (It is on the Ford 3000, though). I noticed a good bargain on some 14.9x28 6ply from Tiretown ($210 vs $235 on the 13.9x28 (4-6ply). I understand that the 14.9x28 are a little over an inch wider, but would the tire's height be much higher? The 28in wheels also have cast iron weights on the inside of the wheels. I have serious hills to climb on my land when brush hogging and need all of the traction I can get. I sure wouldn't like to go back to the original standard size.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.