Posted by Ultradog MN on October 14, 2010 at 19:36:19 from (71.34.10.213):
I'm about to put some new pistons in a 3 cyl Ford 4000. Interference, valves and head on these engines. Test fit of the pistons shows them to raise a little higher above the block than I feel comfortable with. Machine shop can shorten my rods about 10 thou for about $65 apiece. I could cut 10 thou off the tops of my pistons in a lathe for free. Adviseable? Or not? I know racing engines have pretty close tolerance on piston and rod weights. How close are run of the mill, out of the box tactor pistons weightwise to one another? How about rods? Normally I would throw these in and not give weight a second thought. But cutting them makes me wonder. Could I make a difference in balance? 3 cyl engine aint the smoothest to begin with. Maybe go locate my local drug dealer and ask to borrow his gram scale to weigh my pistons? I could do a little fileing and weighing if it would do me any good. Make it smoother. Maybe this is rediculous stuff to even think about on a 2200 rpm tractor. But I want to know just the same. And this is a good place to ask. Thanks to any and all.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.