Posted by Don-Wi on October 09, 2010 at 20:10:01 from (75.198.76.28):
Our neighbor borrowed our NI 290 haybine last week. He's known for being hard on equipment, but being that we borrow his 2 chopper wagons all the time, it's hard to say no once in a while.
Cut to the chase.... He says he'll be over on Sunday to pick up the haybine. Dad and I look at each other like "yeah right" and go on about our day. Turns out he wasn't able to come and get it until Thursday. He cut for one day, and had it the rest of the week. Dad calls and says we need it back to cut a swamp for bedding, so he brings it back the next day which is now Friday. He never narrowed it up to go down the road, and this is a 9' cut machine. He pulls into the driveway and backs it to one side, and before unhooking it asks Dad if he can just leave the head down. "No! Dad says. We always lock it up when done using it, or else it'll stretch the springs out." He said he didn't narrow it up because "It's too hard...." I guess I don't understand how hard it is for him to find a rut to sink the outside wheel in to narrow it up on his farm.
He also said he's gonna need it again because he didn't get everything cut that he wanted to. I guess I just don;t understand how he can have it for a week, and not cut everything he needed. The sun was shining all week, and hardly anything else has moved on his farm the whole time.
This is the same guy who never got his corn in this year, and didn't get his bean in last year because he wasn't finished building his custom planter. Another neighbor even offered to let him use his drill just to get them in, but he claimed that it would waste too much seed. Would have been better to waste some seed than to not get it in at all, but I'm not gonna ponder that one....
On the plus side, there actually was a different color grease on the machine than we use, so he must have actually greased it before running it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
