Posted by John Harmon on October 05, 2010 at 17:05:53 from (174.26.165.238):
In Reply to: Plowing terminology posted by IaGary on October 04, 2010 at 20:09:32:
My dad never had a square field on any of his farms being located along a river.He sort of plowed in a square.Around and around the outside edges of the field until he got some where close in the center that he could go from side to side on a headland at each end then he would plow out the headland.He would plow back into the dead furrow for about 5-6 rounds and disc all dead furrow depressions out. Some years he would start the plowing on the opposite side of the field and end up with the dead furrow crossing the last one at 180 degrees. Corn fields only got plowed every 4 years as a rule. He followed a corn,oats hay,hay and pasture rotation for many years.Some of the hilly fields were terraced and were farmed around the hill.Corn was never much of a cash crop but was fed mostly to the Dairy Cows,Duroc Hogs and Chickens.Making feed was a twice and some times a three times event every week with the old hammer mill never given much rest. He wore out 4 hammer mills and 2 Artsway feed mills that I can remember.I left home in 1955 and sort of lost track of what went on at the farm but this much I can remember about plowing and such.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
