Hitch to deck is 4 ft. 5" frame forms tongue via mitre at front edge of the deck. The tongue is doubled inside the 5" with 8" x 3/16 channel, also mitred at the front of the deck then continues 4 ft beyond the mitre below the deck.
15 ft of deck in front of the axles centre point, 12 ft behind. Axle spread is about 3 ft.
Trailer is 8 ft + a couple of inches wide. I'll have to measure the frame, about 6 ft though, its tight to the single wheels that tuck under the rub rails. Cross members are pretty widely spaced, maybe 18-20", I assume that is why the deck is so heavy. A quick calc tells me when the hemlock deck is wet (always up here) it weighs almost 2000 lbs.
It doesn't seem to have much problem with torsion, the are a couple of extra crossmembers and frame structures for storing ramps in the middle that stiffen it up in torsion, but I haven't dared load it heavy after finding the rust.
I'm considering chopping 3 feet of the back as well, as I don't absolutely need it to be so long. I've also considered goosenecking it when I do the frame work and moving the axles rearwards instead of shortening. Not sure on that though.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.