Posted by rustyj14 on September 22, 2010 at 18:15:00 from (72.95.220.227):
In Reply to: lift-crane for trailer posted by Cal Innes on September 22, 2010 at 17:42:06:
A friend of mine collects junk from various places, and he has a hydraulic pump and ram mounted at the rear of the truck bed, in the outer corner. He hooks onto say an engine block, then pumps the thing until it raises the heavy object, and then he can swing/pivot the whole thing around, and deposit the object in the bed of his truck. The pump and ram look just like one from a hydralic jack from an engine crane, as used by car mechanics, or who-ever. NOTE: If you use the electric winch plan, you could mount the winch on the bottom of the boom assembly, so it could turn with the boom. The electric cable should be flexible enough to turn with the boom. Your idea has many merits, including the omission of much heavy lifting that you would have to do, if you didn't work up your idea. On another note, one day, i bought a wrecked Ranger pickup, and had to flat-bed it home about 20 miles. A friend had a beaver-tail equipment trailer, so he and i took it to where the truck was, and he used one of those Harbor Freight electric winches, and pulled the truck right up and into the trailer, with seemingly little effort. And, operated it with a 12 volt truck battery! So go-follow your plans! It sounds good to me. by: Rusty Jones, the mower man.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.