Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Tractor Talk Discussion Board

Re: weight can tell you much . . .


[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]

Posted by jdemaris on September 16, 2010 at 07:47:01 from (67.142.130.41):

In Reply to: Tractor Batteries posted by Matt Weltz on September 16, 2010 at 05:36:57:

Battery weight usually tells you more then any CCA rating. But, HD/severe service batteries often have less power per weight then LD batteries. That because some of that weight is for vibration-resistant reinforcement instead of battery plates.

All the CCA rating tells you is how many amps the battery can supply at zero degrees F for 30 seconds at 7.2 volts minimum (for a 12 volt battery). It does not tell you how long that battery can supply power. Note also that a 12 volt system tractor usually cranks at 9 volts.

CA rating is similar but at 32 degrees F.

You didn't give any measurements, so it's kind of hard to make suggestions. Also, the word "power" has little meaning by itself. Two equal "power" batteries can be rigged differently internally.
Actual weight of the battery usually tells you the most. One can be made supply a large rush of cranking current for a short time, while another can supply medium cranking current for a much longer time. That's why batteries get rated in "cold cranking amps" along with "reserve capacity" or "amp-hours." It's the amp-hour or reserve-capacity rating that tells you how long that battery can supply X amout of power.
CCA alone tells you hardly anything about power in general. You need both of those specs to see if you are gaining anything.

A decent large battery usually has a good CCA and RC/AH rating.

Some examples, same battery size, light to heavier:

BCI type 31 battery. Weighs 41 pounds. Measures 13" long by 6 3/4" wide by 9 1/2" high. Has 650 cold cranking amps at zero degrees and 145 minutes of reserve capacity.

BCI type 31. Weighs 41 pounds. Measures 13" long by 6 3/4" wide by 9 1/2" high. Has 650 cold cranking amps at zero degrees and 145 minutes of reserve capacity.

BCI type 31. Weighs 54.5 pounds. Measures 13" long by 6 3/4" wide by 9 1/2" high. Has 760 cold cranking amps at zero degrees and 170 minutes of reserve capacity.

BCI type 31. Weighs 58 pounds. Measures 13" long by 6 3/4" wide by 9 1/2" high. Has 1000 cold cranking amps at zero degrees and 185 minutes of reserve capacity.

BCI type 31 but commercial/severe duty. Weighs 62.5 pounds. Measures 13" long by 6 3/4" wide by 9 1/2" high. Has 650 cold cranking amps at zero degrees and 180 minutes of reserve capacity.


Replies:




Add a Reply

:
:
:

:

:

:

:

:

:

Advanced Posting Options

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.



 
Advanced Posting Tools
  Upload Photo  Select Gallery Photo  Attach Serial # List 
Return to Post 

TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and ... [Read Article]

Latest Ad: Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy