Posted by KYfarm on September 10, 2010 at 05:34:21 from (74.128.24.86):
when I walked into Sears last night I answered the question that the kid at the register asked me, which was "can I help you find what you are looking for today?" Usually I say no thanks because I don't enjoy idle chitchat with strangers but I didn't know where the item was so I made the mistake of telling him.
"Sure" i say, "I'm looking for a set of calipers" immediately he changes the look on his face and says to me "brake calipers"? like it is the first time I've ever been out of the house and I'm an idiot looking for auto parts in sears. "No" i say "calipers, like a measuring device" he responds "for measuring brakes?" and passes me off to another kid who knows less and says somethng under his breath that I know was a rude comment about my intelligence, I start walking and the "manager" says to me "are you looking for a micrometer?" Sure I say show what you have because this all has reaffirmed my theory about talking to strangers. I follow him and he shows me a micrometer on the wall, I immediately grab a set of calipers next to the micrometer and show it to him. I explain that this device which was clearly labeled "caliper" is what I was looking for and it actually isn't designed to stop a car and that maybe the employees of the tool section should actually walk it a few times a night so that they knew what was on the shelves instead of talking to customers like they were the idiot.
The calipers looked like they might last a week and had an accuracy of about 50%, I left......very frustrated
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.