Posted by Dave from MN on September 08, 2010 at 16:00:11 from (75.94.148.103):
Ok. Piece of land jsut about 1/3 mile from me could be available for rent, however due to high taxes in the area, the owner would like close to $100 an acre. The ground is level, a little rocky in a few spots but not bad, one of the fields is light soil, the remaining(larger of the total acreage) is pretty decent heavier soil. Most land I have now I pay from $25-$55 an acre( all non irrigated) in 2 counties, but in my county all the land I rent/own is on one section, renting it will put me in two sections, and possibly 3 (looking for enterprise units to save $$ on RA) if I get another piece I am after( cheaper rent though). It seems like high rent , but when I read what others are paying I feel I need to take into account what I would be paying per acre on average of all the land I rent, plus figure in the reduction of crop RA premiem's. It also is in an area that would qualify for soil conservation programs, and I beleive it is in DCP. I want to grow, it's close, I have alot of chicken manure to cut down costs, so corn would be failry profilable on average years, but beans would be hard to make it profitable on a poor year. Just wopndering what some of you think, or have done in this situation. I am spreading out and land is very hard to get around here. Owner and myself are gonna think about it for a couple weeks, he had mentioned doing it on shares, some thing I havent done before, is that a better option?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
