Posted by jdemaris on September 02, 2010 at 06:12:28 from (67.142.130.39):
In Reply to: excessive oil use in 6.5 posted by Martin Caldwell on September 01, 2010 at 18:36:19:
I can't say for sure what your problem is . . . but it's pretty easy to pull the pressure-hose off the turbo and check it. Look for too much side-play, signs of scrubbing, etc.
Yes, 6.2s and 6.5s will blow out oil like crazy if the crankcase-venting system stops working. I wish they just used to old pre-emissions draft-tube like a farm tractor.
Not long ago, my turbo 6.2 starting blowing oil all over the road. Never used any oil to speak of previously. Then, all-of-a-sudden, I lost 4 quarts in 50 miles. Guess what the problem was? Oil filler cap up to had fallen off and stop the crankcase vent system from working. I was at least 50 miles from the nearest parts store and they did NOT have the cap in stock. So, I cut out a chunk of my rubber floor mat and used a hose clamp to seal off the oil filler tube. Then drove 300 miles and didn't use a drop of oil. Later a $2 cap from NAPA fixed the problem correctly.
Note that the same thing happened to a friend of mine, in his 95 Dodge-Cummins truck. He was on a trip down south and oil started blowing out his rear main-seal. The repair shop said they'd have to pull the engine apart and he'd be delayed a week. He couldn't wait, so he bought two 5 gallon pails of oil and kept driving. Later, after it got even worse, another shop fixed it in 10 minutues with NO parts. It was a crankcase-vent problem.
Your engine uses a CDR , i.e. a crankcase depression regulator. Believe it or not, General Motors recommends that you replace both the oil filler cap AND the CDR valve every 30,000 miles. If I had done that, my old cap would not have fallen of and caused my problem. Gasket dried out, cap fit loose, and fell off on a bumpy road.
GM test for your vent system is this. Attach a water-manometer or equiv. to your dipstick tube. At engine idle, it should read no more then one inch. At 2000 RPM, 4 inches max.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
