Posted by Alan Jacobson on August 31, 2010 at 23:50:50 from (72.208.68.99):
I"m working at finishing restoration on a 1950 Farmall H with row-crop front wheels. While packing the wheel bearings on the left front wheel, I discovered that the inner and outer bearing grease retainers are completely missing. The up-side is that this allowed me to remove much of the "ancient" grease in the inner cavity of the hub. The right side still has both grease retainers intact.........but I would like to remove them so that I can remove the old grease in that right hub, as well. The retainers are held in place by the bearing cup (race) on either side of the hub. I"m wondering if I can just use a punch or drift to buckle each retainer to the point where it could be yanked out "by the roots", so to speak. With today"s modern lubricants, I don"t think those retainers even need to be there but I really don"t want to get into the nasty task of trying to remove the cups (races) just to get the retainers out. Any one else encountered this problem? Thanks. Alan
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.