Posted by trucker 40 on August 27, 2010 at 19:32:22 from (69.152.39.240):
In Reply to: How to plow a field posted by Negligence on August 27, 2010 at 15:03:56:
This works if the field is square,which is the only way Ive plowed is a square field.You start out on one end of the field and plow throwing the dirt towards the edge of the field.You dont throw the dirt towards the center,you throw it to the edge,with the furrow going towards the center of the field,when you get to the other end,and if there are any rows you can see count about 50 or 75 and go back.You will be throwing dirt towards the center of the field,then go around and around,running your front tire in the furrow if you have a wide front end and your plow is set that way,and once it gets hard to turn make a new land,by going from the same end of the field another 50 rows past where you were before and finish the last few turns out by coming down the new land side and going up the old land side until you have a dead furrow,and then you go back to going around the new land,repeat until you get all the way across.If you somehow get crooked then you have to plow out the dead furrow to where you have just one furrow. I cant help you on terraces but it gets more complicated there.You plow the terrace and work inside between the terraces and not across the terraces,is about all I know about it. So9me people like to go across the rows,but it can get rough that way especially if the combine cut ruts.Some people like to go at an angle with a chisel plow.Mostly people dont plow nowdays,or if they do its with a chisel plow.If the ground has ever been plowed a lot it can help it to chisel plow it deeper than the plow went.Dirt that was plowed year after year develops something called hard pan and if you chisel plow it deep enough it will break through the hard pan which is sometimes better depending on what kind of dirt you have.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
