The solenoid winding is an electro-magnet. When you energize it - it pulls a metal swing-arm that acts against the shut-off spring. I.e., power creates magnetism that pulls against the spring and puts the pump in "run." Cut the power, and the spring shuts the pump off.
If you took one assembly off (cover with solenoid, plunger and swing-arm), put power to it and saw no movement - I'm assuming that is because the metal swing-arm was already all the way over in "run" position. You DID say it wouldn't shut off, so I assume that's where it was. If so, it can't move any further, bad or good solenoid.
I wasn't disputing your problem or your sucessful fix. But, I know some people on this forum don't realize how that solenoid works - and the same type is also used in many farm tractors.
The older solenoid-swing-arm assemblies had no plunger to get stuck inside of them. The later ones do. Probably what happened is what Bob mentioned. Some debris got stuck in the plunger, plunger stuck in its bore, and the swing-arm got stuck in "run" position. I've seen many do it. Usually pretty easy to pull it apart, clean it and get it working.
The older solenoid assembies had no plunger to get stuck. But, the plunger was added because the plungerless assemblies had the reverse problem. They wouldn't always pull the pump into "run" position. So between the two versions, I guess I'd rather have one that got stuck in "run", rather then one that got stuck in "no run."
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.