To be honest, the right tool for the job is going to get you the best results, chipping and hacking away at it with impact and or hammer type tools makes for a sloppy rough opening, that will require repair, surfacing etc. in most instances.
3 course thick, I agree, hire it done from a concrete cutting outfit with a concrete chainsaw, cuts wet no dust, accurate and will leave you with a smooth rough opening, without fracturing beyond the rough opening, potentially weakening the wall etc.
There are other methods, but these outfits have the right tools, are quick and there will be minimal mess, no dust. On one project I did when in high rise construction I hired out $50,000 worth of cutting, core drilling and the like, some of which was 5000 psi concrete plank with wire strand reinforcing, concrete saw went right through it on 10 floors, elevator entrance planks were slightly longer, dimension on the drawings or a mistake by the plant, can't recall, that saw made short work of it.
Typically a masonry doorbuck is mortared in as the brick or block wall is erected, no fasteners, but I believe you should be able to source a frame that can be fastened with the use of a mechanical fastener, like an expansion bolt, sleeve anchor etc., like what Hilti, Redhead, Powers, Fastenal can provide, I like Hilti the best.
Only other way is while doing the demo, "tooth out" the courses, then mortar the bricks back in, with the tiebacks/embeds for the frame but with 3 courses, that would seemingly be more trouble than its worth.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Proflie: John Deere Model R - by Staff. The John Deere Model R, the last of the lettered tractors, was the first diesel-powered tractor produced by John Deere with a gasoline starting engine. It was also the first tractor they produced that had an optional steel cab. The photo above shows the tractor w
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
