We (firemen) took training on them last fall, wonderful to say the least.
I wish they made a non gold plated version, they are less than simple to make out of alumn, and its been nine months now, and we still have not made one yet.
I've been on the department and EMS for over thirty years, and I'm here to admit to eveyone we would have killed any man if we were to have tried before the training. We have gotten men out of augers, but never had a man trapped in a bin.
Wake up everyone,--- we buried several of us guys in their training tank -- no one had a clue as to the troubles they were about to try to overcome.
We all had the rope around the waist, and pull thing in our heads before the training. I'm not sure, but a 160 pound man will require 900 pounds of pull if buried to the chest. Actualy 160 pound men in our neck of the woods do not come out in to the public eye. (We is all fat boys)
If you want to walk near unconditioned grain, using a rope, the spine in your back seperates at around fifty pounds of pull.
It was one of the best trainings I have ever had, and I was the first one to protest about loosing another Sat. in training. I should be ashamed of myself.
If any of you folks live near grain bins, you may want to donate (to your fire department) a few of those plastic crates that were used for orange juice etc. I think they are 18 inches wide, 18 inches long, and 18 inches high. (not sure). They are very usefull for the fire departments in a grain bin.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
