Posted by camju on August 10, 2010 at 17:31:09 from (142.161.15.12):
In Reply to: hay cutter posted by jack-iowa on August 10, 2010 at 11:56:59:
Don't know how much hay your making or how much time you want to spend.I have a 489 NH haybine 9Ft I like it much.cost me $1000. 1650 cockshutt tractor and borrow my brothers round baler.Have 346 JD square to do small bales.cost me $1000.Also have cheap side delivery rake but don't use.4400 veratile swather with bean pickup to pickup hay and put in swath.I cut full width and it dries way faster in heavey alfalfa.(I know I'm wierd)cost $2500.If you don't make alot of hay you are better off buying hay from even 100 miles from home than to buy all the equipment and do it yourself. If you have the land and time to do it and enjoy doing it diffrent story.I custom make a neighbors hay (10 acres).she pays $300 a year I cut and bale once only.She now whants to buy all her own equipment to save $300 a year,does not make sence.I always do it on time whenever she asks, but she is independent(also a school teacher).after buying you still have to fix so be prepared to spend some money.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.