Posted by bc on August 08, 2010 at 15:37:51 from (208.189.34.225):
In Reply to: Re: 656 hdy posted by Allan In NE on August 08, 2010 at 08:26:55:
That rock shaft housing does have some stuff they probably wanted to keep covered. If you pull the rock shaft housing cover plate, go easy and preserve the gasket. Easy use of a putty knife is ok. Don't forget to clean the layer of crud in the bottom that develops there. If you oil is milky, it will never clean up cause of that resevoir. Dip it out and change your oil as well. It will still hold a couple inches no matter what as the drain tube back towards the rear is welded solid at the base so it won't screw out. Don't over torque those cover bolts, don't ask me how I know. You may want to have a tap handy.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.