The way you frame this... the first thing that comes to my mind is liability. What is the reason for this job and who's responsible if the results are not up to their specifications? Some big liability insurance would be in order I think... Be worth a call to your agent and probably a lawyer as to what coverage they'd recomend for you.
As far as discs go... I'd agree that 26" blades are going to be a bare minimum here. With the gear you have you might drag a 9' on the 6400 and mabey a 10' on the bigger tractor... though 8' would certainly be easier for the smaller tractor. I handle a TaylorWay 670 which is 9' behind a Ford 7710... but that's also wound up to over 100 horse... with a lot of ballast on all 4 wheels. Workrate with that setup is 2-4 acres per hour but in this case I'd lean towards the 2 acres per hour figure. I also wouldn't consider it at less than 70/hour... and I'm using farm fuel, I own the disc (which should be more economical than you renting it) and I don't have liability insurance... I'd say you're going to be closer to 100/hour. I'd also probably not want to bother with it unless there was the potential there for some good profit. Too many potential headaches there to work for nothing...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.