Well since everyone is talking about mud and sand. I will tell my tale of snow then. I was using my 730 Case to pull in logs for firewood a few winters back. I was running double ring chains on the tires. Needless to say the old girl could go about any where. Except, when you slid off the packe wheels tracks from a few weeks before. At that time there was about 2-3 feet of snow in the flats with it drifted good along the tree line. My first trips the weeks before packed a nice hard trail on the snow. On that day I slid of the tracks and hung the tractor up on the packed snow. So it was a nice cool half mile walk back to the house to get the shovel. Nope no other tractors ready for winter use. I jump on the snowmobile and get back to teh tractor. When I got the snow dug from around the wheels they were off the ground atleast 8 inchs each side. The packed snow was to hard for the shovel. So, I ened up useing the chainsaw to cut the snow off under the tractor. Moral of this story is, have your wood put up before snow flys! And the walk back to get the snowmobile was just as fun as the walk to get the shovel. Bob
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.