Posted by ryanwheelock on July 14, 2010 at 05:35:31 from (67.59.45.185):
Question with a cylinder I'm using to lift implements behind my farmall H. I bought a 2" shaft Hydraulic cylinder that I wanted to use on my NH haybine, hay rake and Oliver disc. I wanted to use the same cylinder on all 3 but the problem is it'll lift the rake easy and the disc will lift 3/4 of the way up and the haybine not at all. I'm running out of hydraulic power I think. Someone on here weeks ago said he uses a Farmall H and can lift his haybine with the tractor hydraulics. If I went to a 3" shaft size I know it would be slower to lift and would take more fluid but would it give me more lifting capcaity???? If not should I tear into my pump and check the clearances?? Thanks Ryan
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.