Posted by Hobo,NC on June 18, 2010 at 08:10:34 from (75.89.255.35):
In Reply to: Nancy's Oil Change posted by camju on June 17, 2010 at 09:13:03:
JD Seller said: (quoted from post at 06:05:25 06/18/10) I have been the service manager at two different John Deere stores, in the last twenty years. I see the people here complaining about how much a dealership charges. Most dealers make all of the profit in the service department on the parts sold through it. The labor makes very little profit when all of the costs are figured in. That labor charge has to pay all of the following: wages, health insurance, retirement, vacation time, sick leave, electric, water, heat, building maintenance, service tools. SO PAY for all of that and see what you make.
As for the dealer marking up the machining work 100%. I bet that you where paid as soon as you gave him the bill. The farmer might have paid it in thirty days.
We have been living for a long time in a age in which you can no longer be successful in repairing a vehicle with out access to the electronic controls and information...
by now it should be obvious that Albert Einstein and Thomas Edison could not diagnosis these vehicle with out the proper tools are info...
You can not base a simple oil change again what the charge is to repair other systems,,, its hard to break down a A,B, are C job,,, A C tech can not do what a A tech can,,, a B mite be able to,,, I am sure most understand what it takes to reach top level pay,,,, I am sure you will not take less just because the tast is ratted at a C tech level,,,A techs will not work for C tech pay,,, if you are happy with a C tech then stay with him,,, if you are lucky sooner are later he will move up to a B,,, if not then he will get a job driving a truck and the search will B on again....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
